The new (incredibly expensive) djet injector holders arrived and the instructions said no sealant necessary but I just couldn't do it and put a thin smear of O2 sensor safe high temp RTV around the base. I used the very expensive installation tool shown below (hitch pin off my F250 tow bar) it fitted just perfectly and I just placed it in the hole and tapped them in till they seated firmly. You cannot mistake the fell or sound as they seat!

I then installed the new lower injector seals and installed the injectors which i just tightened down on the existing fittings

from there I moved on to the fuel supply system.

Home | new holders and fitting the rail | Fuel supply | Sensors | First Start | Feedback

This site was last updated 05/11/08